HOW TO: Corset Top

This is how I made a corset top from an old dress and a petticoat!

So unlike my previous clothing items I've made, I actually watched a couple youtube videos to help me out. However , I only took guidence from two in particular. The first being from a youtuber I watch, Nava Rose https://youtu.be/c1Gp05TPGcU ; she infact linked the template she used to create hers with, and it is the same i have used. The next video is from a youtuber I've never watched before, Brianna Duran https://youtu.be/ZnpuEkZIlnI ; this video helped be with the last half of the making of the top. (Nava's helped with the first half)

I started by cutting out the template piece (and taped them together if needed). Next, I cut vertically down one side of the petti coat and folded it in half. On the fold, i lined up and pinned the middle portion of the template to the fabric and cut carefully around it. The other pieces didn't need to be on a fold although, i kept the fabric in half so that each side would match. I then

repeated these steps with the lining facbric of the dress. Once this was done I sewed each of the materials individually before sewing them together (INSIDE OUT). I left the bottom edge of the top unsewn so i was able to flip the top the right side out.
The hard part was somewhat over!
I decided to do a top stitch as it would take down that 'puffyness' and make it a neater finish (leaving the bottom again).

...I will admit, i forgot to attatch the straps when top stitching. Although it wasn't too much hassle. I just had to adjust and cut the length of them, undid some of the stitches with the seam ripper , put the straps though and sewed it backup.
Now it's time to add the cable ties (C.T.) for the boning, which was suprisingly quite easy! (I guess this would be classed as the second half)
I started off by cutting off each end of the C.T. and filled them so that it wouldnt be sharp and pierce through the fabric. After, I measured the width of the middle portion of the top to find the half mark. Next, I drew a line straight down with a pen and ruler (pencil wouldnt show up).

I then placed a C.T. against the line and marked down the other side of it, drew a line and sewed down it (I did pin the fabric near the line together to keep it in place)- I repeated these steps, but placed the C.T. at the angles I wanted them at. Once this was done, I put the C.T. through the top but, I cut and filled off 1cm off of each one so that I was able to sew the bottom edge... which I will talk about now. I simply flipped the bottom to the back of the topped, and sewed along the edge (trying not to sew into the pastic)
As the petticoat comes with a tie around the waist, I used that for the string ties for the back. I cut it into four symmetical pieces and then, rolled in the ends of each one and hand stitched them so that they wouldnt be left to fray. I finally attacthed two to each side of the back and i was done!
I guess I'll just have to see what I'll make with remainings of each material :)





Comments